العربية
Ελληνικά
עברית
Русский
Українська
SNAPMAKER U1 3D PRINTER
- Smooth Printing with 5X More Speed and 5X Less Waste
- SnapSwap™ 4-Toolhead System with 5s Tool Change
- Multi-Color Multi-Material Printing
- 4 Toolheads Work As One
- Auto Filament Loading
- 500 mm/s Max Speed, Up to 20,000 mm/s² Acceleration
- 270*270*270mm³ Build Volume
- Automatic mesh bed leveling ensures reliable first layers every time
- Advanced compensation with Pressure Advance and Input Shaping for superb detail
- Up to 80 less filament waste compared to traditional purge methods
- Built for consistency and long-term reliability
Technical Specification
Switch Filaments in 5 Seconds with SnapSwap
Most printers rely on filament changers to switch between colors or materials, spending more time purging than actually printing. With four toolheads preloaded and pre-heated with their own filaments, the SnapSwap™ system lets the U1 switch by simply swapping the toolheads, cutting your wait time from approximately two minutes to only five seconds.
No More Purging for Color Change
Filament-changing printers 'purge' by wasting perfectly good filament—pushing one color through the nozzle until the last trace of the old one is gone. The U1 doesn't play that game. It only purges the tiny amount of filament that's actually degraded by the time a new print job begins, or during flow-rate calibration, cutting waste by up to 80% on every print.
Rock-Solid & Precise Locks
The U1 uses steel-ball kinematic couplings to click each print heat into perfect position, then locks it securely—no screws, no magnets, no extra motors. Locked fast, rock solid, tested over 1,000,000 swaps with zero failures.
Less Waste Means Serious Savings
So. Much. Waste. On other 3D printers, printing a multi-color model leaves a mountain of trash – often 3 or 4 times more material is wasted than actually ends up in the model! The U1 avoids waste through smart tool switching, saving filament, saving money, and even helping the environment.
Toolhead Offset Calibration
The U1 automatically aligns XYZ offsets between multiple toolheads, keeping offsets within 0.04mm for sharp prints without vertical shifts.
Vibration Compensation for Consistent Prints
Input Shaping, aided by a precision accelerometer sensor, reduces vibrations caused by rapid directional changes by pre-processing movement commands to cancel out resonant frequencies. By adjusting acceleration profiles and introducing calculated delays, it prevents surface artifacts like ghosting or ripples, allowing the U1 to deliver clean edges, smooth walls, and sharp details even at high speeds.
Fine-tuned Extrusion for Exquisite Details
The U1 uses Pressure Advance to stay ahead of flow delays, especially during quick moves or sharp corners. It tweaks extrusion timing based on motion changes, so filament flows smoothly even when speeds shift. That means fewer blobs, less thinning, and crisp, consistent detail.